PL30 Manufactured by Alvin And Co Inc - Order Online

Part Number:  PL30
Manufacturer:  alvin and co inc
Item Name :  planimeter
CAGE Code:  23366
INC Code:  04415
Country:  USA
NCB Code:  00
FSG:  66 Instruments and Laboratory Equipment
The NSN Part PL30 Planimeter is ready-to-ship today! Please request a quote by filling out the form. All fields are important. The NSN number for PL30 is 6675-00-813-9108. The manufacturer of this part is Alvin And Co Inc. A dedicated customer service executive will contact you within 15 minutes of receiving the RFQ.

Note : We Will Not Share Your Information To Any Third Parties.

Please fill out below form for PL30

Contact Information

“*” Required Fields Are Compulsory
   * By clicking this box, I acknowledge that I have read and accept the ASAP Semiconductor Terms and Conditions and agree that all quotes and purchase orders are exclusively subject to the ASAP Semiconductor Terms and Conditions.
  • I consent to receive email communications from ASAP Semiconductor and can unsubscribe at any time.
  • ASAP Semiconductor is a wholly independent aftermarket parts distributor.
  • This website is intended for quotations based on part numbers only. Please DO NOT submit drawings, technical data, or other specifications through this portal.

Disclaimer: This is a quotation for the goods listed above. This quotation is meant as an estimate and does not reflect a final bill or invoice. All quotations are subject to change until acceptance by ASAP Semiconductor of a binding Purchase Order, and quotations may be withdrawn or revised at the sole discretion of ASAP Semiconductor. This quotation is subject to the ASAP Semiconductor Terms & Conditions available at https://www.asapsemi.com/customer-terms-and-conditions/ . All United States Government and Department of Defense bids are quoted as CAGE code 6RE77 from ASAP Semiconductor’s Anaheim, California facility. Any quotation from ASAP Semiconductor without 6RE77 is void.

Characteristics Data of NSN 6675-00-813-9108, 6675008139108

MRCCriteriaCharacteristic
ADNMFRAME MATERIALANY ACCEPTABLE
SURFSURFACE TREATMENTANY ACCEPTABLE
BBMZARM MATERIALANY ACCEPTABLE
BBNFNEEDLE MATERIALANY ACCEPTABLE
BBNGTRACER ARM EFFECTIVE LENGTH2.500 INCHES MINIMUM AND 7.000 INCHES MAXIMUM
BBNHPOLE ARM MAXIMUM LENGTH13.000 INCHES
AFJUCARRYING CASEPROVIDED
BBNLVERNIER MINIMUM READING0.010 SQUARE INCHES AND 0.04 SQUARE CENTIMETERS
ANEXCARRYING CASE QUANTITY1
APQBUNIT TYPEPOLAR
ANBWPOINT MATERIALANY ACCEPTABLE

bottom to top